For Sale WTB - Haskel 5 3/4 air drive barrel

[DA Aquamaster]

I'm rebuilding an older version of a Haskel AGT 7/15 for a local dive shop and the 5 3/4" ID barrel for the air drive has some spots inside where the barrel has de-laminated.

I'm looking for lower cost alternative to a new barrel and wondered if any one has one sitting around in serviceable condition. There was one on e-bay for quite awhile, but of course now it's gone.

Thanks.

 

[TrimixToo]

I'm rebuilding an older version of a Haskel AGT 7/15 for a local dive shop and the 5 3/4" ID barrel for the air drive has some spots inside where the barrel has de-laminated.

I'm looking for lower cost alternative to a new barrel and wondered if any one has one sitting around in serviceable condition. There was one on e-bay for quite awhile, but of course now it's gone.

Thanks.

It could probably be bored and sleeved by a machine shop if it's thick enough, and they could also probably just make a new one. No idea whether the cost would be lower or higher. How much is a new one?

 

[DA Aquamaster]

It's a composite wrap, and the gel coat in the inside has delaminated in spots. I suspect what happened is that it developed pin holes, which allowed water in the drive gas to get underneath the gel coat, which then caused the delamination in spots, probably aided my sub freezing weather as it was located under an awning outside.

I'll get an estimate from American Airworks on Monday, but it's a common part on many 5 3/4" Haskels and I'm just checking to see if there's one floating around out there.