absaav
Contributor
Included are swagelok qc6 m/f quick disconnects a $224 dollar value in itself ($56 for 4 parts 2 m , 2f)
Had this attached to my Apeks wsx sidemount kit for about 2 dives while kayak diving.
Just plug in when you jump in the water, clip in your tanks and off you go.
Manifold alone cost me $250.
Had this attached to my Apeks wsx sidemount kit for about 2 dives while kayak diving.
Just plug in when you jump in the water, clip in your tanks and off you go.
Manifold alone cost me $250.
- Marine grade brass with heavy duty titanium coating - stronger than chrome coatings and it resists finger prints
- Weighs 3lbs
- Mounts on a standard Z-Harness top plate or Backplate with adpater
- 8 ports for input or output
- 4 Right Side Ports (Primary regulator, BCD LP hose, Input hose, RB Diluent hose)
- 4 Left Side Ports (BAck-Up Regulator, Drysuit LP Hose, Input Hose, Diluent Hose)
- Isolator Open - Gas is allowed to all 8 orts
- Isolator Closed - Gas is seperated in left and right side (4 ports each)
- Ideology is excatly the same as UTD/DIR Backgas Doubles (Open during dive, all regulators and BCD/Drysuit and Dil functioning, Closed during emergency, so left and right side)
- Intended for overhead environments to support redundancy regulator theory
- Isolator knob is located right behind divers head for easy access (mush easier than set of doubles)
- Allows for 2 inputs and 6 outputs
- Allows for isolation into 1 iput and 3 outputs per side
