Spiegel Grove - Forward Machinery Space video

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Capt Jim Wyatt

Hanging at the 10 Foot Stop
Staff member
ScubaBoard Business Sponsor
ScubaBoard Sponsor
ScubaBoard Supporter
Scuba Instructor
Divemaster
Messages
4,764
Reaction score
4,485
Location
High Springs - Cave Country
# of dives
5000 - ∞
Yesterday brought me back to the Spiegel Grove. I have been planning engine room / machinery space video dives for a while ... Its 130 feet deep in this, the forward machinery space so gas goes pretty fast & deco builds up quickly too. Lots of silt in there and the water is not as clear as on upper decks. There is no water exchange in there as there are no holes in her side and only small openings to get inside. There are layers of silt & what appears to be rust in the water which slightly restricts visibility.

This video taken 10/26/14 shows the entry vertical via a trunk (shown early in the video)down two decks. The video shows the boiler, (Spiegel Grove was powered by 600 pound steam.), and air compressor, one of the fresh water makers/condensors. Water was made by auxiliary steam flashing sea water to its boiling point and collecting the condensate, pure water.

This is definitely an advanced wreck dive due to several factors. Silt, overhead environment, percolation with open circuit, several lines and at least one tee in there that can be confusing if proper marking is not done and overall this is a relatively small space.

No one should attempt this dive without the proper training.


[video=youtube;3XYQr_RpbCM]https://www.youtube.com/watch?v=3XYQr_RpbCM[/video]

Shown below is a screen shot from my Shearwater Petrel from this dive

Screenshot 2014-10-26 19.41.04.jpg

 
I love that wreck. Being a Navy Chief, I am pretty comfortable navigating inside this wreck. The layout is very familiar, albiet not as familiar as it is to you Jim. What most folks wont realize by watching this video is how tight the passages get as you go deeper into this wreck. If you dont have your stuff together, it is very easy to get a siltout. Maybe one of these days you should deliberately silt out a compartment(just a little science experiment), and show folks how dangerous this wreck can be. The silt is so fine in there that you dont get to many f-ups.

Keep posting Jim, I love your videos.

-Tom
 
Tom - You are absolutely right about both the small spaces and the silt-out potential. We know of several divers who have perished diving these very spaces due to loss of visibility, which was due to lack of training.

Check out this video that I just uploaded made after I left the machinery room and headed aft to the exit. It is part of the same dive shown on my Petrel dive profile.



[video=youtube_share;XFCAJkTyNmc]http://youtu.be/XFCAJkTyNmc[/video]​
 
https://www.shearwater.com/products/perdix-ai/

Back
Top Bottom