Cds1785
Registered
l purchased this used in hopes of utilizing it for a travel BCD; unfortunately it doesn’t fit me so there is no sense in holding on to it.
- Large shoulder section with 4 D-rings, adjustable chest strap (high and low position). Shoulder section appears to be newer.
-medium lower section/ waist panel. Overall good condition, appears to be slightly older than the upper section. Slight corrosion can be noted in the grommets on the lower section
- 44lb horseshoe wing. Dual lower dump valves with shoulder dump. Currently has an Octo + on it. I can not comment on the functionality of the Octo + as I had planned on changing it out with a BX inflator. Since I am not keeping the unit I did not make the switch. I did however briefly attach the normal inflator to check the integrity of the bladder. Everything held air well with no leaks noted.
- Zeagle quick release rear trim weight pockets.
- dual cam bands
- ripcord weight system
The only “issue” I found was that the clips on the outer edge of the wing are missing. The loop is intact and my plan was to use shock cord to hold the wing down if needed. The missing clips in no way affect the functionality of the wing but want it to be known to any potential buyer.
Paypal only.
$200 w/ free shipping to CONUS
- Large shoulder section with 4 D-rings, adjustable chest strap (high and low position). Shoulder section appears to be newer.
-medium lower section/ waist panel. Overall good condition, appears to be slightly older than the upper section. Slight corrosion can be noted in the grommets on the lower section
- 44lb horseshoe wing. Dual lower dump valves with shoulder dump. Currently has an Octo + on it. I can not comment on the functionality of the Octo + as I had planned on changing it out with a BX inflator. Since I am not keeping the unit I did not make the switch. I did however briefly attach the normal inflator to check the integrity of the bladder. Everything held air well with no leaks noted.
- Zeagle quick release rear trim weight pockets.
- dual cam bands
- ripcord weight system
The only “issue” I found was that the clips on the outer edge of the wing are missing. The loop is intact and my plan was to use shock cord to hold the wing down if needed. The missing clips in no way affect the functionality of the wing but want it to be known to any potential buyer.
Paypal only.
$200 w/ free shipping to CONUS
