Jak G
Registered
A dive buddy asked if could 3D design and print a bump cap for the top of the MK17 EVO first stage. His cap got damaged somehow.
I drafted it up based on the MK17 first stage that I use. Turns out, they are two different sizes. Of course.
It was easy enough to modify the design to suit the MK17 EVO, so now both designs are available.
They are on OnShape at SB Mk17 EVO bump cap. This should open OnShape, and there are two tabs - Mk17 v1 and Mk17 EVO v3.
Click in the Parts area, and export as an STL.
(When I upload to Thingiverse or similar, I will add a link).
MK17 EVO v3 in black PLA+ has keeper lines in it, the MK17 EVO v2 in gold PLA did not, and slid on and off the EVO a bit too easily.
The MK17 v1 in gold PLA fits my MK17 first stage quite well.
I drafted it up based on the MK17 first stage that I use. Turns out, they are two different sizes. Of course.
It was easy enough to modify the design to suit the MK17 EVO, so now both designs are available.
They are on OnShape at SB Mk17 EVO bump cap. This should open OnShape, and there are two tabs - Mk17 v1 and Mk17 EVO v3.
Click in the Parts area, and export as an STL.
(When I upload to Thingiverse or similar, I will add a link).
MK17 EVO v3 in black PLA+ has keeper lines in it, the MK17 EVO v2 in gold PLA did not, and slid on and off the EVO a bit too easily.
The MK17 v1 in gold PLA fits my MK17 first stage quite well.
