Re-installing Air inflator/Air Source

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

T

the sharkman

Contributor
Messages
194
Reaction score
0
Location
Northern Cal
I am getting ready to purchase a Balance (Seaquest) BC. Right now I have the ProQD+. How difficult will it be to remove and re-install my airsource/ inflator hose to the new BC?
:guitar:
 
The hoses should be the same length so if you unscrewed the setup from the QD it should screw right on the balance. No big deal........IMO. Post your results.
 
You don't need the entire hose. Just unscrew the clamp on the Air Source and hook it to the inflator hose on the Pro QD.
 
iscuba once bubbled...
You don't need the entire hose. Just unscrew the clamp on the Air Source and hook it to the inflator hose on the Pro QD.
Click to expand...
You don't need the shoulder fitting, but you DO need the whole hose.
The Airsource hose has a separate attachment point for the inner cable (for the pull dump) at the midpoint of the hose, which allows you to operate the pull-dump while breathing the reg.
 
I just realized how easy it is to just unscrew the whole thing at the shoulder. I guess you just screw it back on hand tight, without any type of sealant, right?

Thanks for the replies,

:guitar:
 
You must log in or register to reply here.
https://www.shearwater.com/products/teric/

Back
Top Bottom