BjFaeTorphins
Registered
I will point out up front that i've not actually got my OC1 wet yet.
I've tried setting FO2 for TMT 1. i.e. the %O2 for tank 1 to 30%.
My TMT is not connected to a tank so the pressure setting is 0 and flashing.
After a while when I go back in to look at this setting F02 has gone back to "Air".
I've tried DFLT ON and OFF. Makes no difference.
How and why does this happen?
I've tried setting FO2 for TMT 1. i.e. the %O2 for tank 1 to 30%.
My TMT is not connected to a tank so the pressure setting is 0 and flashing.
After a while when I go back in to look at this setting F02 has gone back to "Air".
I've tried DFLT ON and OFF. Makes no difference.
How and why does this happen?