New compressor for Christmas?

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

rcontrera

Contributor
Messages
913
Reaction score
116
Location
Washington State
So ... you got a new compressor for Christmas! Congratulations!!

But, before you get too far into playing with the new toy, let's make sure you set it up right.

First off, read your manual (yeah right ... most guys won't until something breaks but I had to say it anyway). Now, do a visual inspection to see if everything looks right ... no lines coming apart, no bent tubing, no obvious defects or damage, etc. If it is an electric motor driven machine, either install the proper plug or have it wired into a box (depends on which motor you have). If you have a fuel driven engine, check the engine oil and fill up with the proper fuel.

Now grab your little adjustable wrench and your bottle of leak detector as well as a rag or paper towel to wipe the oil from the dip stick. Check the compressor oil level and inspect the filter cartridge to make sure it is installed and in good condition. Start the motor/engine for a few seconds to make sure the compressor is turning in the right direction. Once you are sure of the direction, open the fill valve and drain valves and start her up. Air will be flowing out the drain valves and the hose so close the drain valves and the fill valve. Watch as the pressure rises and note where either your pressure switch shuts down or the relief valve lifts and mark it on your log (should be a sample in your manual) ... oh, and shut it down.

Now you are ready to fill so hook up your properly inspected tank, start her up again and watch as it fills. If you have auto drains, note the time between operations. If you have manual drains, crack them open every five to ten minutes for a few seconds until all the moisture is gone. When pressure builds up a bit, spray the connections with your leak detector and make sure everything is tight. If you find a leaker, DO NOT TIGHTEN UNDER PRESSURE ... you could damage the fitting. Mark the offending fitting, shut it down and bleed the system. Then snug up as needed.

Of course, there is a lot more to learn, but this is just a starting primer so you can have fun with your new Christmas toy! Enjoy and take care of her.
 
Ray,

I must ask just how many folk, your neck of the pond buy a compressor for Christmas?

Over here we tend to settle for socks or a jumper.

I drive past the Coltri factory on my way to Lake Garda. This week it's been shut all week.
Maybe all the crates from China stacked up outside round the back are full of socks. LOL Iain
 
Ten years ago, I thought exactly the same as you. Who gets a big dollar item for Christmas but big dollar people? And big dollar people doesn't describe our divers!

Then I sold one and they said it was a gift. As they years progressed, more got sold around the holidays and I know of at least six folks this year that got them. Kind of blows me away since I usually only get a cheese log and my big gift is a bottle of booze!

Happy New Year to you Iain.
 
https://www.shearwater.com/products/teric/

Back
Top Bottom