Need help in properly threading an Oxycheq buckle on an

[diver 85]

Oxycheq hog harness.....Have everything else done on the BP/W & harness(I believe---lol) correctly but can't figure out the PROPER way to get the buckle threaded.....Have it on & it may be the correct way but want to make sure.....Found a video @ ST(kinda vague@ the end of it), but it's for DR buckle(left hand release)--this will be a righthand release..If I can't get any help here, I'll call Ed tomorrow @ Caveadventurers & get it done...TIA & any help would be appreciated....

 

[rstofer]

Have you seen this: Hogarthian Harness Assembly Instructions

In through the outside slot from the bottom, down through the inner slot, up through the middle slot and back down through the outside slot.

It makes no difference if the buckle is left or right handed, the webbing goes through in the same way.

Richard