Micro Bubble setting on Aladin Square

[Tony387]

I have reviewed the manual several times and still cannot set the micro bubble level on my computer. After getting into the Scuba Settings function and progressing through Maximum Depth and Maximum Dive Time, when I get to the Micro Bubble Level screen, it reads only "off." The manual says to use SELECT and once flashing, adjust to level from L0 to L5. The only message I get is "off" in the lower right hand corner and using the SELECT button does nothing. I have used the computer on one dive since purchasing it a few days ago. All my other settings are correct and I really like it a lot...just can't seem to figure this out. I was hoping you could help.

Thank you

 

[JulesSCUBAPRO]

Your computer has been set to Gsauge Mode and the MB level cannot be adjusted until the computer is taken out of Gauge Mode. To turn off Gauge Mode, go to Scuba setting>Mode. Once entering mode, you be able to scroll to Gauge mode and change it to Scuba mode.

 

[Tony387]

Thank you for the quick response. I finally figured it out.

Sent from my SCH-I545 using Tapatalk