Looking to get into reg self-service.

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

You don't need two tanks, just check your IP with a full tank, then turn the valve off, and bump a purge a couple of times until the tank pressure reads low, then re-check your IP.

I learnt that from you.
 
You don't need two tanks, just check your IP with a full tank, then turn the valve off, and bump a purge a couple of times until the tank pressure reads low, then re-check your IP.

Haha, I like it! Thanks for the awesome tip. I'm still plugging through Harlow's book, dang work getting in the way of fun.

Hopefully by the time we get back from Lil Cayman in August I'll be able to give it a go. These puppies are about at the 2 year mark give or take a couple months, curious how they look on the inside.
 
I use a compressed air nozzle/blower a lot when servicing regs. Also brass pin punches, and snap-ring pliers. I haven't tried those particular picks, but I like the flat pick included in this set for various tasks. A bench vise with soft jaw inserts is handy, and a 12" crescent wrench works fine on yoke bolts if used carefully. Another much used tool: Dremel with various brass and fiber brush bits for cleaning nooks and crannies of parts, and various diameter bronze gun bore brushes chucked in a drill press for similar purposes.
 
https://www.shearwater.com/products/peregrine/

Back
Top Bottom