krawlings
Contributor
Here is my first shot at making a camera tray for my Intova Sport Pro
I used a length of 1/8" x 17" aluminum bar ,bent it on a vise and 2 chunks of 3/4"plywood (to keep bends flat and as sharp as I could. I used 2- 3.5 "x 1.125" nylon round stock. threaded one end of each for a 1/4 20 nylon bolt . Made a 1.5" x 1/4 narreled thumb nut . I used 1/4 -20 aluminum thumb screws and bolts made a aluminum T- SLIDE for mounting the 18 CM FLEX ARM and mounted my Intova mini light on it. It weights about 3lb. max . I have not gotten it in the water yet to see how it works and it's buoyancy characteristics
I all so made it so I could flip it over and have the flex arm/light lower if needed
I used a length of 1/8" x 17" aluminum bar ,bent it on a vise and 2 chunks of 3/4"plywood (to keep bends flat and as sharp as I could. I used 2- 3.5 "x 1.125" nylon round stock. threaded one end of each for a 1/4 20 nylon bolt . Made a 1.5" x 1/4 narreled thumb nut . I used 1/4 -20 aluminum thumb screws and bolts made a aluminum T- SLIDE for mounting the 18 CM FLEX ARM and mounted my Intova mini light on it. It weights about 3lb. max . I have not gotten it in the water yet to see how it works and it's buoyancy characteristics
I all so made it so I could flip it over and have the flex arm/light lower if needed