HyMark valves

[SeaCobra]

I managed to snap a dip tube off of a HyMark valve and naturally they are a whisker skinnier than the standard ones. To further complicate I am told the valve is no longer being made and no parts are available. Any suggestions on where I can get a dip tube for this valve?

Thanks

 

[Max Speed]

A lathe.

Sent from my SPH-P100 using Tapatalk 2

 

[SeaCobra]

yup, my simple solution is to use a tap and turn down a dip tube to fit it.

 

[Couv]

Why not go the other way? Extract to broken part, re-tap the hole for a standard size dip tube.

 

[SeaCobra]

Hmmm, because that would be way too smart for me and make a lot of sense. Not to mention then the valve would fit a standard tube in the event I do it again and be easy to replace. Kinda kicking myself for not thinking of it myself. Thanks for your help.\
Jeff