- Messages
- 17,268
- Reaction score
- 9,471
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
Nick, a couple of questions re your plates. Ill apologize in advance if i am mistaken. As previously posted i have just bought both your new AL and SS plates. When threading the webbing I have to burn a new hole in the webbing as the centre hole does not line up with any of the holes on the top of the plate, why is that? Why does the plate have three holes in the top as the s25 wing cannot be adjusted up or down either with or without the STA as it then hits he lower dump/opv, that being the case I'm wondering why you didnt just have one top hole and have it line up wih centre grommet on harness webbing. Also the lower dump on the S25 wing hits the bottom of the plate, only just but it does none the less.The slots also need some re finement, the slots on my new plates are very sharp and required undoing and re threading of the webbing using webbing sleaves as after less than 40 dives the webbing was being cut into particularly the shoulders.Your website is still showing older plates.Thank you.