Depth Gauge

[santacruzscuba]

Looking for ways to clip an analog depth gauge module to harness. Any brass and glass DGs out there?

Seriously though, the best I've been able to come up with is using one of those single-gauge housings that hook onto your hose mid-line, and strap that to a D ring. Or use a DG wristmount and hook that thing onto the harness(not preferred, and I'm trying to have less on my wrists). Any other suggestions?

 

[tbone1004]

stuff it into a thigh pocket if you feel like you need to carry one

 

[Anthony A.]

Depending on what brand DG you have, DSS sells wrist bungee mounts that are designed for dive computers, however many DG's fit in them perfectly such as the Tusa brsnd. If it fits, you can then instead of using bungee cord through the holes, tie a boltsnap to it.

 

[santacruzscuba]

Depending on what brand DG you have, DSS sells wrist bungee mounts that are designed for dive computers, however many DG's fit in them perfectly such as the Tusa brsnd. If it fits, you can then instead of using bungee cord through the holes, tie a boltsnap to it.

Yeah this was the most feasible solution, just wanted to see if there were any secrets on the board for a lower profile setup with just the module no mount

 

[Aviyes]

Epoxy some bike tube rubber to an edge/back to give you a flexible loop to attach a clip. No idea if it works, just a thought.