Atomic Aquatics Swivel - Turrets

[Scared Silly]

Ever wanted to convert your Z1/Z2 that has a fixed turret into one that swivels? This upgrade normally runs $100 but I have one and perhaps two swivel turrets that are not going to be used that I am selling for $65 each shipped.

Note with the right tool, a spanner wrench swapping the turrets is very easy. However, I like using the Pin-lok tool which removes any chance of marring the reg. I can do this procedure for you as I have the Pin-lok tool but it would require sending me your reg and and $5 for the additional postage. Any atomic tech should this tool as well but you should be prepared to pay them for their services.

 

[papanano]

sent a pm

 

[Scared Silly]

There is still one forsale. I am also rebuilding another B2 like I did here:

http://www.scubaboard.com/forums/classifieds-regulators/305294-atomic-b2-yoke-mares-1st-stage.html

except this one will be DIN.

 

[Scared Silly]

Just got the B2 rebuilt and fully serviced. As noted this reg is DIN. Both the first and second stages were stripped and fully serviced. HP (jet seat) and LP seats, all o-rings, hose, front cover, exhaust cover, knob, etc have all been replaced. Well over a $100 in new parts and service, just add an octo and you are set. $300 shipped CONUS. If you want an Z1 Octo add in $75 for it.

 

[Scared Silly]

Reg sold pending payment. Swivel is still available.

 

[Terrill]

Was going to buy, but changed my mind.

 

[Islandheart]

Sent PM...........

 

[Scared Silly]

Just for clarity I am not selling the often highly sot after swivel hose that Atomic makes. I am selling a swivel turret that goes on the first stage. It replaces the fixed turret that comes on the Z1/Z2 first stage.

 

[Scared Silly]

Bump $50 for the first stage swivel turret ...

 

[Scared Silly]

Turret sold!!