A few years old out of warranty. My Atom 2 has started to act up.
Sometimes on my 20' stop, it starts flashing "too deep" and shows random depth like 220', 150' 180' etc. this might go on for a few seconds or a few minutes and then it's all good again (no, my buoyancy isn't that bad.)
I have left the battery out for a couple of days and replaced it with a brand new one. If I press the M button for more than 2 sec, instead switching through the modes like Norm, Gauge and Free, all it does now, it displays a blinking "A-D". If I jump in the water with it, it works in gauge mode just the way it should, until the depth error starts.
I can't seem to find what that "A-D" means, any idea?
David
Sometimes on my 20' stop, it starts flashing "too deep" and shows random depth like 220', 150' 180' etc. this might go on for a few seconds or a few minutes and then it's all good again (no, my buoyancy isn't that bad.)
I have left the battery out for a couple of days and replaced it with a brand new one. If I press the M button for more than 2 sec, instead switching through the modes like Norm, Gauge and Free, all it does now, it displays a blinking "A-D". If I jump in the water with it, it works in gauge mode just the way it should, until the depth error starts.
I can't seem to find what that "A-D" means, any idea?
David