Aqualung Titan Din Connector O-Ring Question

[Peter Guy]

I have a Din conversion kit on one of my Titans and need the proper O-ring info. This is for the O-ring that sits behind the "big" part of the Din converter.

Anyone have a suggestion as to:

a. What is the O-ring? or

b. How I can find (online?) a diagram which will show me which O-ring?

Thanks.

 

[Van Isle]

googling "aqualung 103172" gives some results for Aqualung Spare Parts lists, and service manuals. 103172 is the AL part # for the DIN conversion kit.

I think you're looking for o-ring 820017

VI

 

[keyshunter]

Peeter,
By big part, do you mean the female threaded part (1031-74 din adapter) which screws onto the Titan body--o-ring #8200-77. Or, do you mean the handwheel retainer #1050-56, which screws in with a 6mm hex wrench and uses o-ring 8200-72?

 

[netmage]

http://www.airspeedpress.com/OringDbase.pdf

 

[Peter Guy]

All -- yes, I was looking for the -17- Oring. Stopped by the LDS and talked with the owner who had some old titan kits with spare Orings and we looked and decided it was probably "this" one. Took it home, popped it in and it worked.

My big problem was trying to decipher the AQ part number with the Oring sizes!

 

[oldmossback]

All -- yes, I was looking for the -17- Oring. Stopped by the LDS and talked with the owner who had some old titan kits with spare Orings and we looked and decided it was probably "this" one. Took it home, popped it in and it worked.

My big problem was trying to decipher the AQ part number with the Oring sizes!

Measure with a calipher the inside dia of the o-ring...or better the inside dia on the recess on the reg the o-ring fits over.....then the dia thickness of the o-ring itself
( note: they come standard in 2 sizes: example: 1/16 thickness is either .060" or .070" and so on)...... and then go to this website for matchup;

Marco Rubber Online Ordering Store

 

[Jack Hammer]

I used the 017 o-ring when I converted two Titan 1st stages from din to yoke. Fit fine, no problems a year later.