WhiteSands
Contributor
- Messages
- 668
- Reaction score
- 79
- # of dives
- 200 - 499
Apeks makes an ATX setting tool for adjusting lever height. Does anyone know the measurements for the height of the tool for pass/fail settings? Thanks
PS: This tool is used for setting lever height on the ATX series of Apeks 2nd stages. You push it on the purge button, and if the lever height is setup correctly, when you press the "Fail" tool to the purge button, no air should come out. If you press the "Pass" tool, the 2nd stage will purge.
PS: This tool is used for setting lever height on the ATX series of Apeks 2nd stages. You push it on the purge button, and if the lever height is setup correctly, when you press the "Fail" tool to the purge button, no air should come out. If you press the "Pass" tool, the 2nd stage will purge.
Last edited: