teknitroxdiver
Contributor
What size allen wrench fits the hex hole in the middle of the part that converts the first stage from yoke to DIN? (Part #345-1010)
Allen size for DIN kit?
- Thread starter teknitroxdiver
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
sclakediver
Guest
I think that's a 6 mil
crpntr133
lost, even with a compass
I am pretty sure that 1/4" works as well. 6.35mm=1/4"
I know that I didn't use a metric allen on mine.
I know that I didn't use a metric allen on mine.
It is a 1/4" inch.
Cheers
Chris
Cheers
Chris
ScottZeagle
Contributor
- Messages
- 2,353
- Reaction score
- 72
You guys ROCK!!!
OP
teknitroxdiver
Contributor
Thanks guys! When I unscrew the yoke and install the DIN part, do I need to add any lube or anything?
crpntr133
lost, even with a compass
Scott, that will be another t-shirt...size large please! PM me and I will give you my address.
I didn't lube mine but that doesn't mean that it shouldn't be. A little lube on the o-ring could be a good idea.
As far as the .35mm..pretty small but like I said I know I didn't use metric and it worked. Kinda like I changed a Scubapro MK2+ over to DIN the other day. It was metric and I wasn't going to buy one so I used what I had. Being Scott says that we rock I would say that 1/4" would be my first choice.
PM me and I will give you my address.I didn't lube mine but that doesn't mean that it shouldn't be. A little lube on the o-ring could be a good idea.
As far as the .35mm..pretty small but like I said I know I didn't use metric and it worked. Kinda like I changed a Scubapro MK2+ over to DIN the other day. It was metric and I wasn't going to buy one so I used what I had. Being Scott says that we rock I would say that 1/4" would be my first choice.
OP
teknitroxdiver
Contributor
I tried a 1/4" and it fit perfectly....I think the metric would be too small.
sclakediver
Guest
Sorry about that. I got it mixed up with the size for my DIN insert. Next time I'll go check before I post. Maybee it's a good thing I said ''I think.''
Similar threads
