3d printing

I posted a 3D Printed Focus gear for the Lensbaby Velvet 56mm lens on Thingiverse. https://www.thingiverse.com/thing:6475564 The Lensbaby Velvet 56mm is a Manual Focus lens only. There is no autofocus ability. This project will build a Focus Ring to allow the lens to be effectively used...

These are port plugs I made to fill the through holes in the cordura shell that are exposed when I remove the redundant bladder. When sidemount diving with a drysuit, I find my chest is too cluttered with two power inflators and a suit inflator. I don’t need the redundant bladder as drysuit...

I ran into some issues with wanting to move where my Nerd 2 was positioned relative to my eye, while still using the adjustable Revo mount. I created a 3d model of the original part then created 2 different sized extensions that add 10mm or 20mm to the original part. It does require a bit of...

You asked! We listened! Let me introduce you the Fist Free Breakaway Connector for X-deep Bolt Snap (S size)! There are three versions of clip with inner/outer diameter: (A) 10/18mm (B) 11/19mm (C) 12/20mm Was too lazy to go to storage room to get some hoses and I had only my Deep6 reg with...

I hate sneaker nets. You know what I mean. Flashing an SD card, walking it over to the 3D printer, and setting everything up right there. When it comes to 3D printing, one of the more popular solutions is OctoPrint, or if it's set up on a Raspberry Pi, it's called an OctoPi. It sits on my local...