Search results

Been to NC quite a few times on de-gas days from diving and have never seen anyone there actually diving. Some snorkeling but no scuba.

So search is not currently working and I have just scheduled a last minute overdue vacation to CZM. Who or where is the current best car rental operator? Thanks!

REPLACE!

Order the same screw except in stainless steel from McMaster-Carr. We have several of their lights and it works much better than their nylon counterpart.

We always mount with the turret down. It places the hoses in a little better anatomic position and definitely helps to decrease the possibility of being a head banger.

McMaster-Carr for both o-rings 1-- Chemical-Resistant Viton Fluoroelastomer O-Ring Super-Resilient, 2 mm Wide, 26 mm ID 1295N255 2-- Chemical-Resistant Viton Fluoroelastomer O-Ring 2 mm Wide, 12 mm ID 9263K176

When I get a little time I'll pull up my account from McMaster and find the part numbers.

Look at post #2. McMaster-Carr is a good source.

Yes. I use it all the time with ours.

It is normal for there to be a little freeplay or wiggle when not pressurized. It should tighten up when pressurized and swivel but have MINIMAL freeplay. The question is when it gets to be too much. It is usually the plastic washer under the nut to the swivel. If you experience a leak or start...

You need either the tool or a pin wrench that size. Either way all warranty (such as it is) is gone.

And as the OP, everyone will be pleased to know that Scubapro NEVER did anything, Period. No contact or communication whatsoever.

81 degrees all over Turniffe Atoll last week Diveskin only!

Use MacDive or DiveLog. Both are MUCH better software and do not cost a lot.

MODERATORS!! Is it possible to get the politics out of this thread and just stick to the topic at the top?? There is way too much crap here irrelevant to the original posting. Short time ban a few if it does not improve! Thanks!

Finally found it this morning! Hope it is correct. Oring size for the Sol&Luna computers : 2mm x 12 mm Oring size for the Sol&Luna transmitters: 2mm x 26 mm

I looked for an hour last night but could not find what I needed. Does anyone know the o-ring size for the battery compartment for a Scubapro Galileo Sol or Luna? Any help is appreciated!

Tridacna is correct. Scubapro corporate quit monitoring this forum several years ago. Every now and then someone from the past drops by but Scubapro will NOT see nor take action from anything posted here.

To date my wife and I have dove Devil's throat over 5 dozen times over the last 20 years. It always seems like there is a "never done that" person on the boat at least once a week, usually toward the end of their week there. Yes, it is a bucket list dive and it IS NOT an air only dive. We dive...

They work.