I'm not familiar with the mask or part, but do lots of 3d printing.
Some parts are used for 60psi+ CO^2 carbonation (using beer kegging fittings to carbonate beverages from used plastic coke bottles and the like). We make carb-o-ritas (carbonated margaritas ;-) and similar.
The quality of the...
Thanks for the replies. For now I'm going to hand on to the gear until I get a chance to service and dive it.
Also in the bin was a scubapro Mk1 and a Dacor Olympic 100 - tiny and simple looking.
I think I read that, somewhere here. Not sure what I will do with it, as it's not in the best condition (the knurled knob has seen channel lock pliers) - it also only fits 2 of the 6 tanks I purchased with the gear (5 steel and a LP14).
The back of the top regulator is curved (I didn't get a picture)- where the scubapro all seem to be flat - so you probably have the clone part correct!
Thanks for the quick reply!
I bought a bunch of used gear, these were in the the bin of parts, but they look a bit different from what I can find online. Any ID help would be appreciated! (hope the image shows up!)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.