My Z2 rebuilt last year hasn’t been in the water and the seat has taken a set. Wave washers is in place, I tried to blow through the inlet port and couldn’t.
Any ideas from the Atomic guru crowd.
It has been stored connected to a standard LP hose not the supplied Atomic hose.
From the G250V step-by-step maintenance procedures…
At this point, it’s now time to verify, that we are able to generate a venturi assist.
- Remove the inline adjusting tool and attach the LP hose directly...
- Now simply position the DIVE / PREDIVE control in the PREDIVE position and purge the...
Just bought a new MK2i and was planning on diving Friday to get it wet for the first time. Having an issue with air integration data from the transmitter, in single gas setup the reading is low compared to two SPG’s and an Atomic computer. With a tank at 1830 psi, the descent reads 132 psi...
Hey all, I was testing an MK10, initial IP readings first video. Second video is after the regular was pressurized for a while noticed this strange bounce in ip while taking a breath.
Tried two different 2nd stages same result.
Any idea what would cause this?
Question for the techs… So the OEM airflow specs for the MK25 says 301 SCFM. I tested this on my Dwyer flowmeter and only measured 30 SCFM.
Is this false advertising or might I be doing something wrong?
Connected an LP port to the flowmeter opened the valve fully, tested with and without the...
Made of 316 stainless, flats use a 11/16 wrench. Price will be in the low $20 range each depending on quantity of production run, need at least 40 pieces to keep cost down.
Reply to this thread with Qty. you want and I’ll send you total cost including shipping.
Thanks,
Made of 316 stainless, flats use a 11/16 wrench. Price will be in the low $20 range each depending on quantity of production run, need at least 40 pieces to keep cost down.
Reply to this thread with Qty. you want and I’ll send you total cost including shipping.
Thanks,
Sample below G250V jam...
Does anyone recognize the manufacture of this test panel Alec Peirce is using seen in the below picture?
Just can’t make out the logo, there’s a manufactures website but can’t make it out either. Hoping someone recognizes the manufactures logo. Thanks
How do you like you US made little vise? bought the same one on Amazon great little vise but I find you cant torque anything with it, pulls off the table.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.