Search results

Diveavenue did not answer until now. Does nobody have any information about this valve? I can hardly imagine.

No, not the same at all. Unfortunately. My valves has 300 inlet, 200 outlet.

No unfortunately it is not the same. Housing is different. Perhaps inside parts are the same, I will ask Diveavenue. But it is Coltri branded so Diveavenue is probably not the producer and Coltri does not support those kinds of valves anymore.

Thank you, I fixed it.

I use this valve on my compressor, I got it from Coltri years ago. Now it's leaking, I need a service kit. Coltri does not sell this valve anymore and has no service parts as well. I was told this valve is not produced by Coltri, they buy from anywhere. Does anyone know the producer? Thanks for...

I had 2 MCH6, they died after 50 hours. My friend had 2 MCH6 in his dive shop, they died after 50 hours. Dying meens they were scrap metal: broken pipes, piston destroyed, krankshaft destroyed, lot of blow by. It was not worth repairing. Sell your Coltri MCH6 as long as it works.

I do not have experience in bungee cords. Are they as reliable as springs? Sounds like a good opportunity. Where to buy them? Spring must have a static line, no doubt about this.

Thanks for this information. Hollis is difficult to get in Europe too. But I will try.

Difficult to get Zeagle Recon spings in Europe......

I am not sure if these springs will work. In the Zeagel Recon spring is attached by one screw only, different from other fins I know. The spring's diameter is 11.5mm, Fins intake is only a littel bit larger.

No they were not to short but they failed.

Are you sure, ANY spring will work? If diameter is 1mm to large it will not fit into intake.

One spring strap on my Recon fins is dammaged, the spring is streched. Where can I buy new spring straps which fit Recon fins? Are there any straps which are stronger then the Recon straps? I was a bit disappointed about this failure. Thank you.

They do work very fine, perfect quality. Great!

The Metalsub hoses made to measure work very fine. Exactly the right length, very good quality as far as I can see until now. And price is very, very low for custom made hoses.

Great thank you, I will try them all.

I did help. I was able to recalibrate at 0.00 m, now everything works fine again.

Divesoft answered: this can be reset by myself in the menu. I'll do so tomorrow, hope this helps.

I was diving today. Both Freedoms seemed to show correct depth but I am not 100% sure about it. After dive both Freedoms showed 0.1m at surface. Strange. I am not sure if they need repair. I will write to Divesoft.

During last dives I used the Freedoms in clear water only and they where stored at 400 m altitude. Dives started at 400 m as well.