Search results

  1. S

    Two (and a half) more fusion/p-valve questions...

    You've got a lot of "wiggle room" so to speak as far as the the valve placement-that's what the hose is for. Then again I keep my valve higher up my thigh.
  2. S

    Two (and a half) more fusion/p-valve questions...

    I laid on the ground and put it where if felt comfortable. Also if you look at the drycore there is a template already drawn on it. Their placement was right for me.
  3. S

    Alabama Point Jetties

    Oh man I feel a trip coming.
  4. S

    Layover time in Houston

    Your return flight should be fine. I've made that same Continental flight from Bonaire, it's the early morning one. Done in 45 minutes.
  5. S

    Fusion questions

    For drying I use some aerobics elastic leg toners. Easier than dealing with a drysuit hanger. Just loop the booties through the keepers and hang the band over a line or the top of a door.
  6. S

    Fusion questions

    Have you taken a drysuit class or had an experienced DS diver show you the ropes?
  7. S

    2 Large suit and wrist seals leak

    Do you have the seals above or below your wrist bone?
  8. S

    Fusion and p-valves -- How to handle the Lycra?

    Here's my install using silicon glue. I burned the edges of the lycra with a soldering iron then tried gluing rubber gaskets to both sides of the lycra to prevent future tearing. Unfortunately the glue didn't take to the lycra. So I'll settle with this final version.
  9. S

    P-Valves Poll for Fusion

    I have the halcyon and punched a hole through the lycra. I tried gluing a couple of rubber gaskets to both sides of the hole for reinforcement but they won't stick to the lycra.
  10. S

    Fusion and p-valves -- How to handle the Lycra?

    I bought the easy $7 quick connect.
  11. S

    Fusion and p-valves -- How to handle the Lycra?

    Well there's a good enough reason to avoid it.
  12. S

    Lightweight alternative to Jet Fins?

    OMS Slipstreams. They weigh 5lbs combined.
  13. S

    Fusion with Mk2 - what water temps ?

    Ok 68F is warm in the MK2 not too hot. 78F is friggin hot. You owe me some Polars dude.
  14. S

    Fusion Review Part I

    I think I'll take a Dremel to it just in case.
  15. S

    Fusion Review Part I

    Dove it today. The bulk didn't make much of an impact. Still have the lycra piling issue after just one dive.
  16. S

    Fusion with Mk2 - what water temps ?

    Well I dove the Fusion with just the shell and diveskin to soak up any sweat in 78F. Actually got a little chilly.
  17. S

    Fusion and p-valves -- How to handle the Lycra?

    Do you have a recommendation on what glue to use if aquaseal is bad?
  18. S

    Fusion with Mk2 - what water temps ?

    I'll try it in 78F water tomorrow to let you know.
  19. S

    Whites Fusion: First dive impressions

    It's still snug getting in and out of the fin. Suction effect.
  20. S

    Whites Fusion: First dive impressions

    Scott I had the same setup as you. I had to use longer springstraps. XL Jets have a smaller foot pocket than XL Slipstreams so don't go that route.
Back
Top Bottom