Search results

Thanks Sent from my iPhone using Tapatalk

Does anyone know a source for bulk felt pad material? Im sure it can be purchased somewhere in sheet or roll form but can't seem to find it anywhere.

Yes you are correct, get the VIP + hydro and you won't have a problem. they are 01 Luxfer US S80's, 6061.

Old thread I know but someone might benefit, regarding the spool oring installation. I use an ordinary pencil eraser, lube the oring place it on the eraser, put the edge of the spool on the oring and just push down. the oring will pop onto the spool no worries, works 1st time every time and...

Hi All Im toying with the idea of building a fill panel to run off 4 banks. Bank air pressure will be higher than what I will be filling any cylinders to. So my question is about controlling that pressure and flow. I like the idea of using a regulator to control final pressure purely for the...

it worked with the full version of macdive, don't know what i was doing wrong but all is good now. Thanks.

cheers guys, I get my gear from the dive centre tomorrow and will have a play....

Hi, Has anyone had any luck getting the DG03 to work on a mac? I'm trying to get it working for mac dive and/or sub surface. I have tred these with no luck so far. Virtual COM Port Drivers http://www.ftdichip.com/Drivers/VCP/MacOSX/FTDIUSBSerialDriver_v2_2_18.dmg I'm not all that computer...

Some regulators have a harder life than others, Dive centre hire gear for example is often in terrible condition. Tec divers regs flooded from shut down drills, or a staged cylinder leaking down. Manufacturers take this into consideration when recommending service intervals, I think its more a...

High failure rates after service can only really be technician error. +1 for following manufacturer guidelines, I service my gear every 100 dives.

In short yes. I use christolube or other ptfe lube for everything, i find they are all much the same (christlube, trilube, no brand ptfe lubricant) and don't degrade to the extent silicone grease does. So every oring i touch gets the christolube if it needs lubrication (bear in mind that not all...

+1 for the hot water. its still pretty difficult with the DG03 but i got mine out eventually with no damage to the original mount.

are you asking about a revision "N" manual? I'm not aware of a revision "N" whats the reg's serial number?

I wouldn't say that, it also depends on the tanks, person and setup in Sidemount. I dive Sidemount with weight right on my butt and I am very head heavy, I'm looking for some heavier fins at the moment but the scuba pro just won't fit my (very wide) feet...

With correct planning however, its a non issue, even in side mount, even with thirds, even at your turn point. 1/3rd in, with well timed switches leaves 1/3rd of total gas in each tank, catastrophic failure of a valve renders one side totally empty, still leaves a third on the other side for...

PM Inbound....

I remember it was in Tulamben in Indonesia, Remember gearing up and taking tanks in the morning, I know it was one of three sites but can't remember which. funny that.... was not that long ago.

Also sidemounting so no need for the mirror - nice idea though

I never really planned to start tec diving but liked the idea of diving alone and was already doing so. I looked at the SDI/TDI solo course (only one available at the time) but decided I would have a skill set more suited for solo diving if I opted for technical training. Now I almost...

Thanks Jim, I have not taken the class but seem to remember reading service info is available to techs of other brand regulators. I am an IDEST approved tech, ASSET member # T1355. I service and repair all makes of regulators, compressors etc. cheers for the speedy response.