I recently bought a used Dive Rite Trek Wing (wanted a little more buoyancy for diving with a lot of lead in cold freshwater)
When I orally inflated it fully, there was pretty significant leaking coming from the dump valve.
OK, take it apart, flip the rubber gaskets over, smear some silicone...
I was never taught this but did it once. It was not a runaway inflation but I realized my inflator was slowly leaking air into the bladder so I disconnected it and used oral inflation for the rest of the dive. Corrosion on the Schrader valve caused it to not fully seal. I cleaned it with white...
Excellent condition Atomic SS1 Alternate Inflator Regulators. Both bench tested and have no leaks / cracking set at ~1.6" on both at 129 psi IP. $150 each. Free local pickup in The Woodlands or add $10 shipping. Buy both, free shipping.
Just got my Mares XR jacket back from service (a certified service center) - but I see that the bladder isn't holding the air when I fill it by lung and mouth. The air is leaking through the medium pressure connection.
Pushing / wiggling the inflate button with very gentle force to the side...
I did some dives in Egypt in the last two days.
Since it was not planned, I did not bring any equipment.
I usually rent my BCD anyway as that is more comfortable for me.
What I noticed two days ago was lots of bubbles coming out of the deflator button of the inflator hose. I have never noticed...
Hi, I have problem with leaking inflation valve on my Ursuit dry suit.
- sitech shell
- tried to clean it
- tried to change it
- no bubbles from hoses
- tried several other inflation hoses
- several leak test of whole dry suit even in shop
- lower depth = less leak, more depth = more...
The only time it happened to me was a slow leak. I just kept dumping the excess air until the dive was over and then replaced the inflator with a spare. It did take a little while to figure out what was going on, though.
Inflator or zipper. I'd suspect the zip not being fully seated at the bottom or your inflator being loose. Take the inflator off and ensure nothing is between it and sealing surface. Next time you get in the suit pull the zip down firmly once you're at the bottom to ensure it is seated.
On a dive trip last week, both my high pressure hose (flex hose connected to a naked SPG) and my low pressure power inflator hose (flex hose with a quick disconnect) were leaking significantly. All of the hoses are less than four years old, as is my Atomic Z2 regulator, and I take care when I...
Thanks for the TR. Sounds like you had a great time and were able to do it within budget.
While what you said is true about the LP inflator hose, in an emergency not being able to quickly and easily inflate your BCD adds to your task load and stress. I've had to disconnect mine once due to a...
I have a Seaskin Ultra neoprene drysuit that I purchased over three years ago. Unfortunately, I have developed a very slight leak which I cannot discover the source. The leak is near the Apeks Power Inflator as my undergarments are wet from there. No matter how I try, I cannot figure out if it...
My power inflator was leaking from the button, so I dissassembled it, cleaned it, and replaced the orings. Now I can't get the inlet valve to screw back in. It doesn't feel like the threads are engaging. Any tips?
Take the inflator valve apart. Note if it's screwed together tightly when you unscrew it.
Make sure any gasket that is supposed to be there is in fact there.
Put it back together and make sure it's screwed together tightly.
Try again.
I recently notice a leak around my inflator hose. When I examined further I could not get the leak to stop. Apparently the integrated plastic fitting has degraded and cracked/failed.
Curious if anyone knows if Halycon might warranty this or should it go straight to the trash?
For sale is a Halcyon Pioneer wing, I believe the 27lb lift version. There is a small pinhole leak just inside the hip dump -- it is in principle reachable with a tool or a finger if one wanted to try a DIY patch fix.
I take no responsibility for the performance of this wing as is, or for the...
This is the way to find the leak. Flip the suit inside out and the same with the inflator. Use a ball or bucket to seal the neck and cups for the wrist. pump it up nice and tight hose down with soapy water. how you repair it from there is up to you.
The last paragraph, of the Tek Tip, at the bottom of happy-diver's posted DGX page, explains how best test leaky inflator theory:
"Want to check your power inflator for a leak? Setup your BCD and regulator on a tank with at least {300 psi | 20 bar} remaining then open the tank valve to...
Hello SB,
I purchased a bare voodoo bc of ebay, and to no-ones surprise there was a decent amount of salt crystals on all of the seals on the bladder(s). If you know how this BC works you know why this may he a more complex issue.
The main back inflate bladder had a dump valve entirely closed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.