CuriousRambler
Contributor
Looking at the manual for the Excursion, there's only one page that covers gauge mode, here's a screen shot:
Two questions on this info:
1) The top line says "Current ATM," which I interpret as "Current pressure." If I've got the computer set to imperial, does this read out as "33.4PSI?" I assume the manual should say "Current Depth," and I'm going to see "75.3ft" here, not current pressure. Is this a correct assumption? I can't imagine any situation where I'd need to know my current atmospheric pressure instead of my depth, but I also don't claim to know all that much.
2) The "Notes:" says I can reset average depth and stopwatch by pressing the Right Top Button during the dive. Does this mean pushing the top right button resets BOTH stopwatch and average depth, with one push? i.e. there is no way to reset my stopwatch without resetting my average depth at the same time?
I emailed support, but don't think my questions were worded clearly, because the answer I got was basically "you can't change computer modes during the dive."
Thanks!
Two questions on this info:
1) The top line says "Current ATM," which I interpret as "Current pressure." If I've got the computer set to imperial, does this read out as "33.4PSI?" I assume the manual should say "Current Depth," and I'm going to see "75.3ft" here, not current pressure. Is this a correct assumption? I can't imagine any situation where I'd need to know my current atmospheric pressure instead of my depth, but I also don't claim to know all that much.
2) The "Notes:" says I can reset average depth and stopwatch by pressing the Right Top Button during the dive. Does this mean pushing the top right button resets BOTH stopwatch and average depth, with one push? i.e. there is no way to reset my stopwatch without resetting my average depth at the same time?
I emailed support, but don't think my questions were worded clearly, because the answer I got was basically "you can't change computer modes during the dive."
Thanks!